1000 BASE transceivers module are kind of small form-factor pluggable (SFP) transceivers module. They are used for both telecommunication and data communications applications. 1000 BASE transceivers module links your switches and routers to the network. The hot-swappable input/output device plugs into a Gigabit Ethernet port or slot.
Ethernet was the result of the research done at Xerox PARC in the early 1970s. Ethernet later evolved into a widely implemented physical and link layer protocol. Fast Ethernet increased speed from 10 to 100 megabits per second (Mbit/s). Gigabit Ethernet was the next iteration, increasing the speed to 1000 Mbit/s. The initial standard for Gigabit Ethernet was produced by the IEEE in June 1998 as IEEE 802.3z, and required optical fiber. 802.3z is commonly referred to as 1000BASE and launches 1000 BASE transceivers module .
There are five physical layer standards for Gigabit Ethernet using optical fiber (1000BASE-X), twisted pair cable (1000BASE-T), or shielded balanced copper cable (1000BASE-CX). And that define the different kinds of 1000 BASE transceivers module .
1000 BASE transceivers module incorporate significant interface circuitry and can only be used for gigabit Ethernet, as that is the interface they implement. They are not compatible with (or rather: do not have equivalents for) Fiber channel or SONET.
There are different types of 1000BASE transceivers module :
1000BASE-T SFP for Copper Networks
1000BASE-SX SFP for Multimode Fiber Only
1000BASE-LX/LH SFP for Both Multimode and Single-Mode Fibers
1000BASE-EX SFP for Long-Reach Single-Mode Fibers
1000BASE-ZX SFP for Long-Reach Single-Mode Fibers
1000BASE-BX10-D and 1000BASE-BX10-U SFP for Single-Fiber Bidirectional Applications
2-Channel 1000BASE-BX10-D for Single-Fiber Bidirectional Applications
1000BASE-BX40-D and 1000BASE-BX40-U for Single-Fiber Bidirectional Applications
1000BASE-BX80-D and 1000BASE-BX80-U for Single-Fiber Bidirectional Applications
100/1000BASE-LX SFP for Long-Reach Single-Mode Fibers
The Telecommunications Industry Association (TIA) created and promoted a standard similar to 1000BASE-T that was simpler to implement, calling it 1000BASE-TX (TIA/EIA-854). The simplified design would have, in theory, reduced the cost of the required electronics by only using two unidirectional pairs in each direction instead of four bidirectional pairs. However, this solution has been a commercial failure, likely due to the required cabling and the rapidly falling cost of 1000 BASE transceivers module.
